Pull the DC-Out cables straight up to lift their connector up and out of its socket on the power supply. Remove the two 7. Lift the power supply upward from its left edge as viewed from the front of the PS3. Continue to lift the left edge of the power supply until it lifts off the two metal posts shown in the second picture.
If present, remove the pieces of tape securing the cables to the body of the Blu-ray drive. Use the flat end of a spudger or your fingernail to flip up the retaining flap on the Blu-ray ribbon cable socket.
Be sure you are prying up on the movable retaining flap, not the socket itself. Pull the Blu-ray power cable straight up to lift its connector out of the socket on the Blu-ray drive. Remove the single 9. Lift the Blu-ray drive slightly by its right edge to dislodge the control board from its housing. After you reinstall the Blu-ray drive, be sure the control board is firmly seated in the lower case before proceeding. If replacing the Blu-ray drive with a new drive, swap the circuit board from your old drive into the new drive.
Cancel: I did not complete this guide. Badges: I have a question I have followed your guide properly and removed my drive and found that the laser and disc loader are both need replaced. My question is when I go online and look for the replacement it sometimes shows just the laser then others shows the driver. I want the entire component as seen in this guide above.
Do these come intact with everything in it when I buy it online. Can you please help. Ive been able to remove the drive and I think it's fixed. To get it back together how do you get that ribbon underneath to go back into the slot? Is there a trick? Jump to: navigation , search. Thanks to drizztbsd and RandomUse. PL3: ef payload. Console Components. Switch boards SW. MultiCardReader MC. Communication Processor CP. Categories : Pages with syntax highlighting errors Console Components Main.
Namespaces Page Discussion. Use this guide to replace your PlayStation 3's Blu-ray disc drive. Replacing a defective Blu-ray drive with a replacement requires swapping the Blu-ray drive board from the old drive onto the replacement. Use the tip of a spudger to remove the black rubber screw cover from the side of the PS3. The screw cover may be underneath a warranty sticker.
This sticker will change appearance, and show "VOID" after it has been removed. Pull the smart plate toward the hard drive bay, then lift it off the body of the PS3.
Be sure to keep track of the small metal bracket loosely held in the top cover, if equipped. There is a plastic hook located in a hole on the top back right hand side corner. Carefully push the plastic hook a bit front the rear of the machine with a spudger to release the rear right of the casing. Lift the Blu-ray drive from the edge nearest the power supply and rotate it away from the chassis enough to access its ribbon cable.
Use your fingernail to flip up the retaining flap on the Blu-ray ribbon cable socket. Be sure you are prying up on the retaining flap, not the socket itself. Cancel: I did not complete this guide. Badges: Not sure myself, need one too. Look under comments section under ps3 laser replacement for more info.
They are supposed to sell them on this website but I think they are still out.
0コメント